C&C Medical Solutions Homepage
Forum Home Forum Home > Troubleshooting > Systems > ATL
  New Posts New Posts RSS Feed - Reconfigure HDI Systems.
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Reconfigure HDI Systems.

 Post Reply Post Reply
Author
Message
caruso122 View Drop Down
Admin Group
Admin Group
Avatar

Joined: Apr 09 2009
Location: Noblesville, IN
Points: 85
Post Options Post Options   Thanks (0) Thanks(0)   Quote caruso122 Quote  Post ReplyReply Direct Link To This Post Topic: Reconfigure HDI Systems.
    Posted: Apr 15 2009 at 4:21pm
Question: I just replaced a board in my HDI 3000/3500/5000 and I am getting an error message - how do I get rid of it?
 
Answer: Perform the following steps until the message disappears.
 
1. Go to the service mode by pressing "superkey" & "0" simultaneously.
2. Login as user - "csr", password - "user"
3. Go to "configuration"
4. Click on "Save installed as expected"
5. Click "ok" to confirm.
6. Exit from service mode and restart the system.

Perform a full system restore (this will re-flash the board PROMS) from the backup MO disk (usually located on the right side of the machine in the compartment near the rear wheel).

Perform a CW calibration.

These procedures should always be performed whenever replacing a front end board.

C&C Medical Solutions, Inc.
_____________________
Christopher Turner
Phone: 317-219-3616 x103
Fax: 317-770-0560
Yahoo IM: caruso122
Skype IM: cturner122
Email: chris@ccmedicalsolutions.com
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down